Uei-test-instruments SMART BELL Manual de usuario descargar pdf (Pagina 14)

SeleCtor aNd diSPlay ParameterS oN uei SmartBell

“ZeRO”–Analyzerisperformingtheinitialzerosetting

CO2(CarbonDioxide)–Directreadingofthecarbondioxidesensordisplayedinpercentage

(%)

Eff(Efficiciency)–Calculatedcombustion(notappliance)efficiencybasedonmeasurements

ofCO2,FlueTemperatureandfuelselected.TheSmartBellcalculatesgrosscombustion

efficiency and automatically determines if the combustion is in the condensing mode to make

appropriate corrections.

X-Air (ExcessAir)–ExcessAiriscalculatedforeachfueltypefromtheCO2measure-

ment. It assumes that the combustion process is running fuel lean. It is important to

make other measurements to confirm that this assumption is always correct.

O2 (Oxygen)–O2iscalculatedforeachfueltypefromtheCO2measurement.It

assumes that the combustion process is running fuel lean. It is important to make other

measurements to confirm that this assumption is always correct.

TFlue (FlueTemperature)–TFlueisadirectmeasurementofthetemperatureatthetip

of the flue probe. This measurement is used to determine the net temperature for use in

calculation of combustion efficiency.

TNet (NetTemperature)–DifferentialtemperatureofTflueandambient(orinletif

set).

BAT symbol-DisplaystheBatterypoweravailable.

Fuels Available

GLOSSARY

Selector Position Display Type

L Oil LOIL Light Oil

Propane PrOP Propane

Nat Gas n6AS Natural Gas

H Oil HOIL Heavy Oil

Wood vOOd Wood

1 2 ... 9 10 11 12 13 14 15 16

Sin comentarios

Uei-test-instruments SMART BELL Manual de usuario Pagina 14