Uei-test-instruments C75OILKIT Manual de usuario Pagina 1

1-800-547-5740 • Fax: (503) 643-6322www.ueitest.com • email: [email protected] MANUAL

The formula for K4 is based on the gross calorific value Qgr. To obtainthe loss based on net calorific value multiply by Qgr/Qnet. Since thisloss is u

E l e c t r omagnetic Compatibility (EMC)This product has been tested for compliance with the following generic standards: EN 50081-1, EN 50082-1and i

EFF (G): Combustion efficiency calculation displayed in percentage. Gross (G) or Net (N) can be set (see MENU). The calculation is determined by the f

Limited WarrantyThe C75 is warranted to be free from defects in materials and workmanship for a period ofthree years (two years on sensors) from the d

IntroductionThe goal of combustion analysis is to maximize the energy obtainedfrom a fuel while minimizing the risk of toxic gases and additional main

Probe ConfigurationOperating InstructionsBefore Use Each Time• The particle filter is not dirty• The water trap and probe line are empty of water• All

Selecting FuelTo set the fuel simply rotate the selector to “FUEL” then press the “UP”or “DOWN” arrows to scroll through the choices. When the correct

The probe depth stop cone provided with the instrument allows theprobe to be used in holes whose diameters range from 1/4 to 4/5 inch(6 mm to 21 mm).T

C75-MAN P. 5Furnaces (CONTINUED): Atmospheric, Gas & OilGas FurnaceVerify proper combustion:• O2• CO• Stack temp• Efficiency(Note: The followi

C75-MAN P. 6SERVICE1. The service mode is used for repair and calibration, and should only be entered by authorized service facilities.2. The firm

C75-MAN P. 7Printing A TestDuring combustion tests the analyzer can print data on request. Withthe analyzer showing the data, briefly press the “P

C75-MAN P. 7Below is a graph of typical combustion, showing the point of perfectcombustion and an approximate location for ideal combustion. You w